PDF Bachelor of Science in Mechanical Engineering

EMM 312: Fluid Mechanics III Continuous Assessment Test I

Continuous assessment test on open channel flow. Defines shooting flow and tranquil flow, then derives that in an open rectangular channel the critical depth is two thirds of the critical specific energy. The calculation is a triangular channel with a ninety degree included angle on a stated gradient carrying a given discharge, where the depth of flow is found using a Chezy constant of fifty-six.

Document preview

First page only

PDF

More materials from the same course.

EMM 314: Manufacturing Work Study Revision Questions with Worked Solutions Question sets for the unit with the calculations worked through. The questions cover why a job is chosen for methods study, the areas to focus on when improving work methods, the reasons for excess work content arising from defects in design or specification, what work measurement achieves, the advantages of work sampling over time study, the predetermined time study approach, and the principles of motion economy as they apply to the human arms and body. The solutions take a work sampling study over five days at eight hours a day with ten operators, fifteen per cent allowances and six thousand components produced, and carry it through observed time to effective time, normal time at a performance rating of one hundred and twenty per cent and the standard time, alongside a stop-watch study of five elements rated at eighty to one hundred and ten per cent. PDF KES 40.00 EMM 214: Electrical Engineering I First Semester Examination Electrical machines paper for mechanical engineers. Covers the working principle of a d.c. generator and the difference between separately excited and self-excited machines, the full power balance of a three-phase induction motor from air-gap power through converted and output power to efficiency, and the no-load parameters of a three-phase oil transformer. Asks for the three tests performed on transformers, the voltage equation of a d.c. machine, synchronous speed and rotor frequency of an induction motor, and how generated e.m.f. responds to changes in speed and pole flux. Closes on the three methods of controlling d.c. motor speed, the three-phase transformer connections and the line voltage, line current and output of a step-down transformer in each. PDF KES 40.00 EMM 312: Fluid Mechanics III First Semester Examination Open channel and compressible flow paper. Defines critical depth and derives it for a rectangular channel, shows the Froude number equals one at critical conditions, and works specific energy, critical depth and maximum discharge for a channel of given width, velocity and depth. Explains shock waves and separates normal from oblique, derives the maximum flow over a broad crested weir, and establishes when a hydraulic jump forms and the depth after it with the loss of specific energy. Continues with the pressure rise when a valve closes on a liquid in a thin walled pipe, treated for a rigid pipe and for an elastic one that stretches, and derives Bernoulli's equation for a compressible fluid under steady adiabatic conditions, applied to the maximum continuous discharge of air from a small orifice in the side of a large vessel. PDF KES 40.00 EMM 217: Principles of Engineering Design First Semester Examination Design paper that starts from why materials knowledge matters to a design engineer and sizes the support posts of a tensile-testing apparatus from yield strength and a chosen factor of safety. Works the design process end to end on a product of the candidate's own: the questions that define the problem, the levels of analysis applied to candidate solutions, designing for safety, the questions that make up a testing protocol, and the options when a prototype fails that protocol. Distinguishes standards from codes and developmental, adaptive and new design, applies ergonomic principles to a hospital bed, and estimates the factor of safety under the maximum shear stress, distortion energy and maximum normal stress theories. Selects a hull material against stated strength, hardness and cost limits, then treats product liability, design constraints, manufacturability, noise, machine elements, bearing selection, and the difference between a model and a prototype. PDF KES 40.00 EMM 214: Electrical Engineering II Examination Electrical engineering paper on the principle of operation of a DC motor, developed torque from armature resistance and current, and separately versus self-excited machines. PDF KES 40.00

From the blog

Study guides and revision advice linked to this material.