PDF Bachelor of Science in Biomedical Engineering

Fifth Year Engineering Project Proposal Guidance

What the proposal must do once a supervisor has been assigned: a critical and analytical specification of the goals of the project, an outline of the strategy and methodology for reaching them, literature references with a comment on each one's relevance, evidence of understanding the principles underlying the project, and the foreseeable problems with the strategies for resolving them.

Document preview

Page 1 of 2 · first page only

PDF

More materials from the same course.

Magnetic Resonance Imaging System Slides on magnetic resonance imaging, built on nuclear magnetic resonance tomography, which uses magnetic fields and radio frequency signals to obtain anatomical information. Works through the reconstruction techniques, including the sequential point method, which divides the sample volume into points along three axes and so fixes the number of NMR signal values that must be acquired, and through the parts of the system: the magnet and its field, the gradient coils, the radio frequency system, the detection system that yields the output signal and the imager that reconstructs and displays the images. Treats biological effects, with heating among the potential hazards, and the advantages of the method, superior contrast between near-identical soft tissues, cross-sectional images in any orientation rather than only at right angles as in computed tomography, and contrast that can be chosen by mechanism. PDF KES 40.00 EBM 510: Electric Motor Drive Systems Continuous Assessment Test Forty-minute continuous assessment paper on electric motor drive systems in which any three of six questions are answered. A three-phase fifty-hertz induction motor with equal stator and rotor resistances of five hundredths of an ohm and reactances of three tenths of an ohm, run at half its rated voltage and half its rated frequency: the maximum torque at the reduced supply as a fraction of its normal value. The wound-rotor induction motor rated twenty-five kilowatts at nine hundred revolutions per minute on four hundred and fifteen volts, fed through a three-phase rectifier and a chopper at two hundred and fifty hertz with an open-circuit line voltage of three hundred and fifty volts and a one-ohm load resistance: the chopper on-time that develops a gross torque of one hundred and eighty newton metres at eight hundred revolutions per minute against a synchronous speed of one thousand. For a synchronous motor, three torques associated with it and two methods of starting it. The derivation of the expression relating torque and speed of a cylindrical rotor synchronous motor. A four-pole induction motor on a fifty-hertz supply: synchronous speed, rotor speed at five per cent slip, and rotor frequency when the rotor runs at one hundred revolutions per minute. And the labelled torque-speed characteristic of an induction motor showing the plugging, motoring and generating regions, with regenerative braking explained. PDF KES 40.00 ECU 400: Impact of Electrical Engineering on Poverty Alleviation in Kenya, Group Presentation Group presentation of the research proposal on electrical engineering and poverty alleviation: the introduction defining poverty as a state without the basic needs of life, the statistics used, the objectives, the literature covered and the methodology chosen. PDF KES 40.00 EBM 505: ABR and Otoacoustic Emissions in the Assessment of Childhood Hearing Loss Lecture on diagnosing hearing loss in children with the auditory brainstem response and otoacoustic emissions: the standard procedure from history and examination through basic tests and investigations to diagnosis, management and follow-up, evoked potentials and impedance, the three-wave and click-train ABR, the types of otoacoustic emission, and how the two are read together in a child who cannot respond to behavioural testing. PDF KES 40.00 Growing Leaders Programme Session 11: Stress Management in Leadership and Management The skills, interventions and techniques of stress management and the part effective leadership plays in it. Covers tracking stress as a leader, finding out what the causes are, writing down the reactions and how they were dealt with, and looking for ways to reduce the amount of stress carried, with the principle that a stressor handled early is easier to manage. Ends on the activity of listing the causes of stress and the strategies for each, discussing the positive and negative aspects of stress, and identifying the coping skills that help. PDF KES 40.00

From the blog

Study guides and revision advice linked to this material.